Interpreting Graphics
11. Look at the model of an atom below. Does the
model represent a metal atom or a nonmetal
atom? Explain your answer.
ng

Answer:

a=v/t (searched)

Explanation:

a=acceleration

v=change in velocity

t=time

(searched)

Answer:

The kinetic energy of the sliding block is =1/2×m×v  

2

 =1/2×4×2  

2

=8 J

Now since there is no friction on the surface then it is a conservative system. So all the energy of the block will be transferred to the spring and will store as a potential energy. Suppose it will compress the spring by an amount of x m. So the potential energy of the spring will be =1/2×k×x  

2

Equating there two energies and solving for x, we will get, 1/2×k×x  

2

=8

Or  0.5(400)x  

2

=8

⟹x=0.2 m.  

Explanation:

Answer:

The earth is heating up.

Explanation:

This is due to human activities, primarily fossil fuel burning, which increases heat-trapping greenhouse gas levels in Earth's atmosphere.

Answer:

Definition of spectral line: one of a series of linear images formed by a spectrograph or similar instrument and corresponding to a narrow portion of the spectrum of the radiation emitted or absorbed by a particular source.

Definition of Wavelength: can be defined as the distance between two successive crests or troughs of a wave. It is measured in the direction of the wave. ... Wavelength is inversely proportional to frequency. This means the longer the wavelength, lower the frequency.

So, the spectrum is the range of wavelength in visible light. While, wavelength is the length of a wave.

Explanation:

I hope this helps!

Answer:

a. 6

b. 6 m/s²

c. 300 m to the right

d. 30 secs

Explanation:

slope = rise /run

60-0/10-0

= 6

b. slope = acceleration = 6 m/s²

c. d=ut+1/2at²

t=10 (segment A last for 10 secs)

u - initial velocity = 0

so d = 0(10)+1/2*6*10²

=300 m

Explanation:

because its speed (v) is 0

The answer should be opportunity cost

Answer:

the condition that distinguishes animals and plants from inorganic matter, including the capacity for growth, reproduction, functional activity, and continual change preceding death.

Explanation:

hope this helps

The magnetic field strength is needed to generate a peak voltage 0.15 T.

The given parameters;

The area of the coil is calculated as follows;

[tex]A = \pi r^2\\\\A = \pi \times 0.09^2\\\\A = 0.0255 \ m^2[/tex]

The maximum emf induced in the coil is calculated as follows;

[tex]E_{max} = NBA \omega \\\\B = \frac{E_{max}}{NA\omega } \\\\[/tex]

where;

[tex]B = \frac{170 }{120 \times 0.025 \times 2\pi \times 60 } \\\\B = 0.15 \ T[/tex]

Thus, the magnetic field strength is needed to generate a peak voltage 0.15 T.

"Your question is not complete, it seems to be missing the following information";

An electric generator has an 18-cm-diameter, 120-turn coil that rotates at 60 hz in a uniform magnetic field that is perpendicular to the rotation axis.

What magnetic field strength is needed to generate a peak voltage of 170 V?

Learn more here:https://brainly.com/question/17238887

Answer:

Explanation:

The force acting on an object given it's mass and acceleration can be found by using the formula

force = mass × acceleration

From the question

mass = 80 kg

acceleration = 2 m/s²

We have

force = 80 × 2 = 160

We have the final answer as

Hope this helps you

Using the principle of dimensional analysis, the representation of Pressure would be [tex] P = F^{1}V^{-\frac{2}{3}}D^{0}[/tex]

Pressure is related to Force, Volume and Density thus :

[tex] Pressure, P = F^{a}V^{b}D^{c}[/tex]

Using dimensional analysis :

Substituting the dimension into the relation :

[tex] ML^{-1}T^{-2}= [MLT¯²]^{a} [L³]^{b} [ML¯³]^{c} [/tex]

[tex] ML^{-1}T^{-2} = M^{a+c}L^{a+3b-3c}T^{-2a} [/tex]

Equating the power ;

a + c = 1 - - - (1)

a + 3b - 3c = - 1 - - - (2)

-2a = - 2

a = - 2/-2

a = 1

From (1)

1 + c = 1

c = 1 - 1 = 0

c = 0

From (2) :

1 + 3b - 3(0) = - 1

1 + 3b = - 1

3b = - 2

b = - 2/3

Hence, [tex] P = F^{1}V^{-\frac{2}{3}}D^{0}[/tex]

Learn more :https://brainly.com/question/25690057

The representation of pressure is:

[tex]P=FV^{-\frac{2}{3} }[/tex]

Given that:

Force F, volume V and density D are taken as fundamental quantities, hence pressure P is:

[tex]P=F^aV^bD^c\\\\(ML^{-1}T^{-2})=(MLT^{-2})^a(L^3)^b(ML^{-3})^c\\\\\\(ML^{-1}T^{-2})=(M)^{a+c}(L)^{a+3b-3c}(T)^{-2a}[/tex]

Hence:-

2 = -2a

a = 1

a + c = 1

1 + c = 1

c = 0

a + 3b - 3c = -1

1 + 3b - 3(0) = -1

3b = -2b = -2/3

Hence the representation of pressure is:

[tex]P=FV^{\frac{-2}{3} }D^{0}\\\\P=FV^{\frac{-2}{3} }[/tex]

Find out more at: https://brainly.com/question/24894056

Explanation:

it is a displacement reaction.

Answer:

The anomalous expansion of water is an abnormal property of water whereby it expands instead of contracting when the temperature goes from 4°C to 0°C, and it becomes less dense. The density becomes less and less as it freezes because molecules of water normally form open crystal structures when in solid form.

Answer: 80.5 miles

Explanation:

3.5 x 23 = 80.5

Given what we know about hotspots and their characteristics, we can confirm that the option that is false regarding hotspots is "A. Hotspots are constantly moving forming chains of volcanoes".

In regards to the study of geology, we refer to hotspots as spots in an oceanic mantle where magma located below causes them to become intensely hot. This heat forces magma and therefore the mantle itself upwards as a tectonic plate moves across the spot, and therefore results in the formation of volcanic chains. Some very popular examples of volcanoes and volcanic islands formed by this method include:

Despite the other options being true, option A is false given that hotspots are stationary elements of the oceanic mantle. Although some scientists believe that there is evidence of the movement of hotspots, this movement is slow enough to not be taken into account.

This question was answered in regards to the complete question found online which states:

Which of the following is NOT TRUE about hotspots? a. Hotspots are constantly moving forming chains of volcanoes.

b. Hotspots are stationary.

c. Hotspots form volcanic island arcs

d. Hotspots lie along an oceanic plate

To learn more visit:

https://brainly.com/question/264008?referrer=searchResults

Answer:

velocity and force

Explanation:

Velocity and force vector diagram represent the force acting on the object.

Diagrams are called vector diagrams to use a vector arrowhead to show the magnitude or direction of a vector quantity. The velocity of an item in motion could be represented in vector diagrams. A vector diagram might be used, for instance, to depict the motion of an automobile traveling down a road.

A force was an influence that will have the power to alter an object's motion.

Therefore, velocity and force vector diagram represent the force acting on the object.

To know more about vector and force.

https://brainly.com/question/11643003

#SPJ3

Answer: the first man does more work than the other

Explanation: because the second man has tool a trolley and a ramp to help him make his job easier

Answer: G

Explanation:

Answer:

H = V t - 1/2 g t^2         V and g are in different directions

-8.2 = V * 6.2 - 1/2 * 10 * 6.2*2 = 6.2 V - 192.2

V = 184 / 6.2 = 29.7 m/s

Check: find time for ball to return to zero height

0 = 29.7 T - 5 T^2

T = 29.7 / 5 = 5.94 sec

The ball must have fallen 8.2 m in (6.2 - 5.94) sec = .26 sec

S = 29.7 * .26 + 5 * .26^2 = 8.1

Answer:

it prevents slipping on the grass while playing

Answer:

to keep their grip on the ground so they won't fall

[tex]▪▪▪▪▪▪▪▪▪▪▪▪▪  {\huge\mathfrak{Answer}}▪▪▪▪▪▪▪▪▪▪▪▪▪▪[/tex]

Gravitational Potential Energy of an object is calculated by formula ~

[tex] \large\boxed{\sf P = mgh}[/tex]

where,

Now, let's calculate its potential energy ~

Answer:

Potential Energy of an object is calculated by formula:

Where,

Now, let's solve the question.

Given,

Now,

We know that,

Potential Energy (P.E)=mgh

[tex] = 3500 \times 10 \times 4[/tex]

[tex] = 3500 0\times 4[/tex]

[tex] =140000 joules [/tex]

[tex]\mathfrak{\blue{DisneyPrincess29}}[/tex]

Answer:

Balance is the ability to maintain body balance when placed in various positions.

----------------------------------------

[tex] \green{ \boxed{ \boxed{ \sf{Lusi \: Adriana} } } } [/tex]

Answer:

A state of physical balance.

I hope this helps you!!!

Answer:

dame la marca más inteligente, por favor

Explanation:

En el campo de la medicina, es la respuesta del cuerpo a una presión física, mental o emocional. El estrés produce cambios químicos que elevan la presión arterial, la frecuencia cardíaca y las concentraciones de azúcar en la sangre. También suele producir sentimientos de frustración, ansiedad, enojo o depresión.

Answer:

El estrés es la reacción del cuerpo al sentirse amenazado o bajo presión.

Explanation:

The 4th state of matter would make an acceptable force field.

The 4th state of matter which is plasma would make an acceptable force field because this fourth state of matter is present in ionized form which has two charges on it i.e. cation which is a positive charge and anion which is a negative charge.

We know that charges attract as well repel other objects if they are strong enough. Positive charge repel positive charge but attract negative charge so we can conclude that 4th state of matter would make an acceptable force field.

Learn more: https://brainly.com/question/25628398

Answer:

A

Explanation:

Answer:

A

Explanation:

Answer:

B

Explanation:

I don't know but its b