What’s clues indicate that a chemical reaction has occurred?

Answer:

Physical Change

Explanation:

Answer:

2.686485288205376 Explanation:

1 grams Iron(III) Oxide is equal to 0.0062622034690102 mole.

Answer:

12.5%

Explanation:

percent blurf = quantity of blurftotal quantity×100quantity of blurftotal quantity×100

So for percent by mass, both quantities are expressed as mass, and it’s the mass of NaCl divided by the total mass of the solution, then times 100%

mass % NaCl = 25 g/175g×100

mass %NaCl = 14.3%

The correct answer is False.

Answer:

Nonpolar

Explanation:

Answer:

3 is the correct I think so

Answer:

They all have a chromate (CrO4-2) ion.

Explanation:

The mass of Fe produced from the reaction is 0.938 g.

We'll begin by calculating the mass of Fe2O3 that reacted and the mass of Fe produced from the balanced equation.

3Zn + Fe₂O₃ —> 2Fe + 3ZnO

Molar mass of Fe₂O₃ = (56×2) + (16×3) = 160 g/mol

Mass of Fe₂O₃ from the balanced equation = 1 × 160 = 160 g

Molar mass of Fe = 56 g/mol

Mass of Fe from the balanced equation = 2 × 56 = 112 g

From the balanced equation above,

160 g of Fe₂O₃ reacted to produce 112 g of Fe.

Finally, we shall determine the mass of the Fe produced by 1.34 g of Fe₂O₃

From the balanced equation above,

160 g of Fe₂O₃ reacted to produce 112 g of Fe

Therefore,

1.34 g of Fe₂O₃ will react to produce = (1.34 × 112)/160 = 0.938 g of Fe

Thus, 0.938 g of Fe was produced from the reaction.

Learn more about stiochoimetry: https://brainly.com/question/16727444

Answer:

Melting point, boiling point, state of matter at room temperature, heat of vaporization, flammability and reactivity

Explanation:

Answer:

A. oxygen

Explanation:

Oxygen is the waste created after photosynthesis.

Answer:

oxygen

Explanation:

photosynthesis are for plants and plants don't need oxygen

31

I think. Protons and electrons share the same number as well as the atomic number.

Answer:

31 protons

Explanation:

Protons are positively charged and electrons are negatively charged so if it is a neutrally charged atom (which most are) the protons and electrons will be equal.

Answer: A. 8.8%

Explanation:

Percent Error Formula: approximate error - actual value divided by actual value (Approximate-Actual/Actual). After those steps are completed, multiply by 100 to make it a percentage form.

0.365 - 0.400 = -0.035

-0.035 / 0.400 = 0.0875

0.0875 * 100 = 8.75%

8.75% rounded to the nearest tenth is 8.8%

The molarity of the diluted standard solution is obtained by calculation to be 0.015 M.

Recall the dilution formula;

C1V1 = C2V2

C1 = Initial concentration = 0.1140 M

V1 = initial volume =  6.50mL

C2 = Final concentration = ?

V2 = Final volume = 50.0mL

Making C2 the subject of the formula and substituting values;

C2 = C1V1/V2

C2 = 0.1140 M ×  6.50mL/50.0mL

C2 = 0.015 M

Learn more: https://brainly.com/question/6284546

Answer:

High trainability allows the owner to train the dog to handle certain things--some dog can be trained as police dogs and can be taught various jobs, so high trainability is very important

When a dog is Viscous, the dog will keep people away from your house, they will be able to keep danger away and because they are viscous they will be able to handle danger.

Loud bark- A loud bark from a dog can help alert other people when there is a intruder, it makes alot of noise so they can attract attention easily.

Quiet Bark- Ideal for pet owners who do not like noise, they bark quietly so they are not a bother to work or anyone doing something.

Answer:

mols solute(K2S) = grams/molar mass = ?

Then M = mols/L. You know M and mols, solve for L.

Explanation:

3.5/0.1

L= 35

Hope this helps!!

Please tell me if I have made a mistake!!

I enjoy learning from them:)

Answer:

0.32L

Explanation:

Use formula of V= wt/mm•M.
To get this information we need to first get the molar mass (mm).
mm:
K - 2 x 39.09
S - 1 x 32.06
K2S - 110.262 g/mol

Now we plug it back into the equation.
3.5g/ (110.262 g/mol) • (0.100M)
= 0.317 L of solution

To round to the correct number of siginficant figures the answer is.
= 0.32 L

Answer:

A single covalent bond

Explanation:

A single covalent bond is when only one pair of electrons is shared between atoms. A sigma bond is the strongest type of covalent bond, in which the atomic orbitals directly overlap between the nuclei of two atoms.

Answer:

Single covalent bond.

Explanation:

Single covalent bond is the type of bond in which only one pair of electrons is shared between atoms.

[tex]\rule[225]{225}{2}[/tex]

Hope this helped!

1. If the surface area of liquid is large then evaporation will be

A. small

B. large

C. moderate

D. slow

B. Large

Evaporation increases with increasing surface area. This is because the greater the surface area (exposed to the air), the more molecules escape into the air.

More surface area = Higher rate of evaporation.

Answer:

Mixture of sand, pepper powder and salt can be separated by dissolving the mixture into water. Sand and pepper powder is insoluble in water while salt is soluble. So they are separated by the filtration method.

Locomotion and movement are brought about by skeletal and muscular system of the body. It’s a coordinated event of the skeletal and muscular system brought by contraction and relaxation of muscles.

Locomotion occurs with help of specialised muscles, muscular and non-muscular by nature.

It involves the interaction of muscles (tendons and ligaments) and skeletal joints and cartilage

Locomotion is a voluntary action which require involvement of the nervous system.

In muscles actin and myosin protein forms cross bridges, consuming ATP.

Hence, to bring about locomotion skeletal and are responsible.

Learn more about locomotion.

https://brainly.com/question/13343069    

#SPJ2

Answer:

The Beer–Lambert law, also known as Beer's law, the Lambert–Beer law, or the Beer–Lambert–Bouguer law relates the attenuation of light to the properties of the material through which the light is travelling.

Explanation:

Please Mark as brainliest

Answer:

Take 49.2-ml of 18.0 M H2SO4 stock solution and pour it into a 500-ml volumetric flask. Fill to the 500-ml line with distilled water to make 1.77M H2SO4 solution.

Explanation:

use the formula M1V1=M2V2

volume must be in liters(L)

[tex](1.77)(500 \times {10}^{ - 3} ) = (18)v2 \\ 0.885 = 18v2 \\ v2 = \frac{0.885}{18} \\ v2 = 0.04916[/tex]

0.04916L × 1000 = 49.16 ml = 49.2 ml

Answer:

5. 0.02 seconds

6. (a) 0.0167 seconds

(b) Period in Lebanon is 0.02 seconds and in the U.S 0.0167 seconds. That means that the U.S. has the faster period.

Explanation:

NaOH.

Na = Sodium which is in group 1 of periodic table which are alkaline metals. all the others are alkaline earths as they are all in group 2.

Explanation:

1397.4 uranium atoms......

The number of moles of a solute per liter of solution is measured using the unit of concentration known as molarity.

Thus, The approach for resolving molarity issues is quite straightforward. This describes an easy way to figure out how molarity of a solution.

Remembering the units of molarity (M): moles per liter, is the key to calculating molarity. Calculate how many moles of the solute are dissolved in a solution's liter volume to determine its molarity.

The molarity of a solution made by combining 23.7 grams of KMnO4 with 750 mL's worth of water. You must first determine the amount of moles of the solute because this example lacks the liters or moles required to determine molarity.

Thus, The number of moles of a solute per liter of solution is measured using the unit of concentration known as molarity.

Learn more about Molarity, refer to the link:

https://brainly.com/question/31545539

#SPJ1

Answer:

When the drill hits oil, some of the oil rises from the ground high into the air. This immediate release of oil is known as a "gusher." Once a reservoir has been located, pumps are used to extract the oil.

What is freshly pumped oil called?

petroleum

Explanation: